PT  - JOURNAL ARTICLE
AU  - Šutka, Jozef
AU  - Medvecká, Denisa
AU  - Koňar, Radoslav
AU  - Bruna, Marek
AU  - Matejka, Marek
TI  - Evaluation of Selected Technological Parameters for Selective Laser Melting of AlSi10Mg Metal Powder
DP  - 2023 May 3
TA  - Manufacturing Technology Journal
PG  - 110--117
VI  - 23
IP  - 1
AID - 10.21062/mft.2023.003
IS  - 12132489
AB  - Reusing the powder across consecutive route cycles is typical in a Selective Laser Melting (SLM) process since it is more sustainable and cost-effective. The theoretical part of the paper is oriented on the explanation of the SLM method principle, construction, and parameters of the device Renishaw AM250 used for manufacturing samples made of AlSi10Mg aluminium alloy. The experimental part focuses on evaluating powders that had been used in the process for a long time with periodic 'rejuvenation'. The main aim will be to monitor whether the samples will be affected and if they achieved the required quality of mechanical properties and compare results with virgin powder and manufacturer sheets for virgin powders. The experimental part further describes the procedures and analysis of the microstructure of the samples. AlSi10Mg aluminium alloy was chosen because of an assumption that it will be sensitive to increased oxygen content. A strong affinity for oxygen uptake exists in AlSi10Mg. Therefore, preventing the contamination, careful handling is required.