RT Journal Article
SR Electronic
A1 Botko, Frantisek
A1 Hatala, Michal
A1 Mitalova, Zuzana
A1 Cep, Robert
A1 Rimar, Miroslav
A1 Bernat, Andrej
A1 Vybostek, Jaroslav
T1 Qualitative Evaluation of Machined Surface of Aluminum Alloy AlCu4Mg1 Depend on Feed Rate
JF Manufacturing Technology Journal
YR 2018
VO 18
IS 2
SP 201
OP 207
DO 10.21062/ujep/78.2018/a/1213-2489/MT/18/2/201
UL https://journalmt.com/artkey/mft-201802-0006.php
AB Aim of the article is evaluation of surface quality parameters Rz and Ra after turning of aluminum alloy. Turning is one of the wide spread manufacturing technologies used in industrial production. Experiment was focused on researching of influence of various cutting conditions on machined surface. Main aim of this article is comparison of surface roughness parameters Ra and Rz depending on feed rate and tool nose radius. Investigation and finding of optimal cutting conditions is necessary for economy of manufacturing organization. Despite extensive research carried out in the area of turning, there is always room for new research.