PT  - JOURNAL ARTICLE
AU  - Čilliková, Mária
AU  - Neslušan, Miroslav
AU  - Mičietová, Anna
AU  - Mrázik, Jozef
TI  - Study of Deformation Processes after Hard Turning through Acoustic Emission
DP  - 2012 Jun 1
TA  - Manufacturing Technology Journal
PG  - 13--17
VI  - 12
IP  - 1
AID - 10.21062/ujep/x.2012/a/1213-2489/MT/12/1/13
IS  - 12132489
AB  - - The paper deals with analysis of deformation processes and related aspects of the chip formation as the chip thickness, the chip ratio and the shear angle during turning hardened steel 100Cr6. This paper investigates influence of feed on the mentioned aspects through the metallographic analysis, calculation of the significant aspects of deformation processes and the following experimental study. This experimental study is based on application acoustic emission sensors. The results in this study reports that feed significantly does not affect such parameters as the chip ratio, deformation angle in the cutting zone. On the other hand, experimental study indicates that increasing of feed in hard turning causes increasing of the process instability and increasing intensity of deformation processes in the cutting zone.